Monday, January 30, 2012

Use of-fine bubble diffusers in indusries


Buyers of fine bubble diffusers for their sewage treatment plant or industrial waste water treatment plant have lots of choices to get when choosing equipment for their project.

Fine bubble diffusers are accessible in numerous forms, including discs, tubes, squares, and rectangular panels, and in distinctive components, including elastomers like EPDM and holey medium like Aluminum Oxide, Porcelain, or HDPE. Many books and papers have been published on the differences between these medium.

Nevertheless, there are yet several queries regarding the supremacy or application of disc vs. tube vs. panel.
Several of the suppliers in the industry make numerous sorts of diffuser, although they tend to favor and advertise one more than the others, generally for business reasons (they have a higher edge on one product) or for reasons of products differentiation (when specified by a client or engineer, it is hard to locate "equal" rivals).

Several checks of oxygen exchange performance have been completed over the years on every kind of diffuser (few of which are posted in the ATV Handbuch), however product development is active, and what was tested in the mid 1980's may not utilize today to modern discs, tubes and panels.

There are few sense ideas to comply with, irrespective of the growth of the systems.

In a correctable system made from expensive stainless steel, the diffuser, which can deal with the most air with the least stainless infrastructure, is going to be an attractive option. Usually, tube fine bubble diffusers are viewed on curable methods for this reason.

In a fixed system where the pipes are bolted to the floor, and longevity and low servicing are necessary, disc fine bubble diffusers are much more popular than tubes.

Where failure mode is important (i.e. catastrophic vs. slow) disc fine bubble diffusers might be preferred over tubes. Tube fine bubble diffusers usually have a big air orifice, hence if there is a membrane rupture or clamp failure; a large volume of air can escape from that orifice, starving the rest of the system.

The deeper the tank, the much less advantage panel Fine bubble diffuser offers in terms of productivity. Panels are typically developed to generate quite fine bubbles. In a shallow tank, this is a benefit, albeit a pricey one since panel systems often carries a hefty price tag due to the level of equipment required to buy and install. Nonetheless, in a deeper tank, much of the oxygen is transmitted by the time the bubble has increased 15 ft that the bubble is stated to be oxygen depleted, thus the benefit
goes away. One must also be cognizant of the head loss of panel fine bubble diffusers, as what is gained with regards to effectiveness from small bubbles is generally lost in extra energy necessary to conquer the high back pressure of panel membranes.

No matter the sort of diffuser, one should consider PTFE coated membrane Fine bubble diffusers (advantages), which may extend the lifetime of the membrane and will also decrease surface fouling also.
 
Usually fine Bubble diffuser is set up in the same tank with flow boosters. This is the situation for the Oxidation Ditch process, for example. 

No comments:

Post a Comment